Troubleshooting - QEP 83200Q Instrucciones De Funcionamiento

5 . DO ensure the blade is mounted with the
rotation arrow in the proper direction and is
securely tightened with a wrench .
6 . DO wear proper safety equipment at all times
when operating the saw . Wear goggles and
dust mask at all times when operating saw .
7 . DO periodically check the blade for cracks or
bond fatigue .
8 . DO ensure that blade is traveling through
water reservoir for wet cutting .
9 . DO NOT operate the saw without all safety
guards in position .
10 . DO NOT operate the saw with blades larger
or smaller than recommended .
11 . DO NOT cut dry with blades marked
"Use Wet ."
12 . DO NOT exceed maximum RPMs
recommended by the blade manufacturer .
13 . DO NOT force the material into the blade . Let
the blade cut at its own speed .
14 . DO NOT cut material not recommended by
the blade manufacturer .

TROUBLESHOOTING

OVerHeatinG OF SaW:
1 . Turn saw off and let it rest until motor is cool
to the touch .
2 . Check and clean the ventilation slots,
removing blockage and dirt .
tHe SaW dOeS nOt Start:
1 . Check that power cord is properly plugged in .
2 . Check outlet power source and circuit
breaker .
3 . Make sure yellow safety key is fully pushed
into switch .
WHat tO dO WHen tHe
aLiGnment iS OFF On tHe 83200Q:
The 83200, 24" Bridge Saw motor or bridge does
not need to be squared up or aligned, since the
bridge does not allow the saw motor to move .
When it appears that the saw is out of alignment,
it is the rip fence that needs to be squared up .
Tools needed:
24" Framing Square, Phillips Screw Driver and
¼" Nut Driver or Pliers
The following steps should be used to align the rip
fence for the 83200Q:
1 . Pull the power unit towards you and lock in
place with the transport screw .
2 . Once the power unit is secured, place the
Framing square firmly against the blade on the
left side of the cutting surface . The square must
be flush with the blade . (See Image A) .
ImAgE A
3 . Slide the square into the rip fence, making sure
the square stays firmly against the blade . Look
for a gap between the square and the rip fence .
If there is a gap, adjustments will be necessary .
(See Image B)
4 . To adjust the gap, first remove the Angle cutting
guide . This will expose two screws in the
aluminum track . Loosen both screws in the
extruded aluminum bar . (See Image C & D)
ImAgE c
Left
Rip Fence
ImAgE d
– 10 –
rip
Fence
Gap
ImAgE b
Right
Rip Fence