Publicidad
Idiomas disponibles
Idiomas disponibles
WASHING MACHINE
If you detect a problem
when using your was-
hing machine, you may
be able to solve it after
consulting the follo-
wing troubleshooting
tips.
If you cannot find the
solution, disconnect
the machine and con-
tact the TECHNICAL
SUPPORT SERVICE
• Why doesn't the washing machine start working?
• Why does the washing machine vibrate or make too much noise?
SAFETY AND TROUBLESHOOTING
Perhaps
–
There is no voltage in the electricity mains.
–
The fuses of the electrical fittings are blown.
–
The washing machine is not connected to the electri-
city mains.
–
You didn't press the on/off button(this button's light
should be on)
–
The programme selector dial is not out.
–
The door of the washing machine isn't closed properly.
When this is detected, the displays that show "pre-
wash" or "end" flash and F04 appears on the display
of the washing machine. Then you should check if the
door is open and close it properly.
Perhaps:
–
The internal fastening screws were not removed.
–
The washing machine is not level.
IMPORTANT
Please do not open the
machine under any
circumstances.There is
no fuse or similar com-
ponent inside that may
be replaced by the user.
Publicidad
