Publicidad
Idiomas disponibles
Idiomas disponibles
Connections
Connecting to the water supply
IMPORTANT:
•
Your washing machine is designed to be connected to a cold-water supply.
•
Your washing machine must be connected to the water supply using a new supply
hose. Do not reuse old supply hoses.
•
Be sure to install the rubber seals provided at each end of the hose.
•
For the washing machine to operate correctly, the water supply pressure must be
between 50 kPa and 800 kPa.
•
If in doubt, consult a qualified plumber.
1.
Connect the elbow end of the hose to the threaded inlet at the rear of the appliance.
2.
Connect the other end of the hose to the water tap. Then ensure the nut is tightened
correctly by hand.
3.
Open the tap fully after connecting the hose to check the installation is leaktight.
To prevent any water leak or water damage, leave the tap closed when the washing
machine is not used for a prolonged period of time.
50
Connecting to the drain
The drain hose can be installed in 2 different ways:
Method no. 1: Position the hose over the edge of a sink using a special "U" device
(not supplied). The elbow should be placed at a maximum distance of 100 cm from the
ground.
Method no. 2:
Attach the end of the drain hose to the drain: the drain hose must be
at least 50 cm and not more than 85 cm from the floor and must not extend more than
2.5 metres.
IMPORTANT:
•
Your house will be flooded if the drain hose comes out of its housing when draining.
•
There is a risk of burns from the high washing temperatures! Fix the drain hose
securely in order to prevent such situations and ensure that the washing machine
takes in and drains water without issue.
•
If the drain hose is raised after its installation, it becomes harder for the water to drain,
and the laundry may be considerably wetter. This is why the heights set out in the
diagram must be respected.
•
To prevent the machine from self-siphoning, do not push the hose down to the bottom
of the drain.
[or]
51
Publicidad
