Powersmart DB2603 Manual De Instrucciones página 76

REMOVING THE BLOWER TUBE
1. Turn blower tube in the direction of arrow 1, so that you can separate the tube.
2. Remove tube in the direction of arrow 2. Do not try to separate the tubes by force or by using tools.
Note: Before disassembling the Blower Tube, be sure the ON/OFF trigger switch is on off position.
CONNECTING AND REMOVING BATTERY
IMPORTANT!
The battery pack is not charged when it is purchased. Before using the power tool for the first time, place
the battery pack in the battery charger and charge. Make sure to read all safety precautions and follow the
instructions in the battery charger section.
To install the battery pack
To install the battery pack into the bottom of the blower, align the rails of the battery pack with the rails in
the blower and push the battery into the blower. To connect the battery, slide the battery pack fully
forward. Until the latch locks into place.
To remove the battery pack
Press the battery release button, Slide the battery pack backward, and then pull or lift the battery out of
the tool.
WARNING:
Follow these instructions to avoid injury and to reduce the risk of electric shock or fire:
•
Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.
•
Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on
any part of the power tool.
•
Read, understand, and follow the instructions.
Fig.2
11