Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Page 10
Figure 1.
Install Jandy TruSense on the Pipe
7.
Open valves if needed.
8.
Turn on power at the breaker to the pump and the filtration system.
Check for leaks.
9.
Connect bonding lug to avoid pH and ORP measurement issues.
NOTE: Connect a minimum 8 AWG (8.4 mm2) solid copper conductor
between this unit and any metal equipment, metal enclosures of
electrical equipment, metal water pipe, or conduit within 5 feet
(1.5 m) of the unit.
For Canada:
All field-installed metal components such as rails, ladders, drains,
or other similar hardware within 3 m of the spa or hot tub shall be
bonded to the equipment grounding bus with copper conductors not
smaller than No. 6 AWG.
Section 4.
1.
Turn off pump and filtration system at the breaker. Pump needs to be in
auto, NOT service mode.
2.
Close the valves if needed.
3.
Remove Jandy TruSense top cover, see Figure 2(a).
4.
Unscrew and remove sensor plugs, see Figure 2(b).
NOTE: The ORP sensor will not be included in Model: TRUSENSEPH.
Jandy
b
pH & ORP Sensors Installation
TruSense Water Chemistry Analyzer | Owner's Manual
®
a
AquaLink
RS
(Rev X or later)
Publicidad
