Publicidad
Idiomas disponibles
Idiomas disponibles
Jandy
TruSense Water Chemistry Analyzer | Owner's Manual
®
Do not connect the system to an unregulated city water system or other
external source of pressurized water producing pressures greater than 35
PSI.
To minimize risk of severe injury or death, filter, pump, and pH and ORP
Sensors should not be subjected to the piping system pressurization test.
Local codes may require the pool piping system to be subjected to a
pressure test. These requirements are generally not intended to apply to
the pool equipment, such as filters, pumps, water chemistry analyzers, or
chlorinators.
If, however, the WARNING cannot be followed and pressure testing of the
piping system must include the filter, pump, water chemistry analyzers
and/or chlorinator, BE SURE TO COMPLY WITH THE FOLLOWING
SAFETY INSTRUCTIONS:
• Check all clamps, bolts, lids, lock rings, and system accessories to
ensure they are properly installed and secured before testing.
• Remove the pH and ORP sensors from Jandy TruSense Water
Chemistry Analyzer and use the provided plugs.
• RELEASE ALL AIR in the system before testing. AIR PRESSURE must
NOT be used for pressure testing.
• Water pressure for test must NOT EXCEED 35 PSI.
• Water temperature for test must NOT EXCEED 100°F (38°C)
• Limit test to 24 hours. After test, visually check system to be sure it is
ready for operation.
Notice: These parameters apply to Fluidra equipment only. For
non-Fluidra equipment, consult the equipment manufacturer.
Follow all applicable electrical codes. Prior to installation or performing
any service, turn off all switches and the main breaker in the pool/spa
pump electrical circuit. Failure to comply may cause a shock or hazard
resulting in severe personal injury or death. While disconnecting and/or
connecting any electrical wiring, be careful not to damage or abrade any
of the wiring.
WARNING/SHOCK HAZARD
SAVE THESE INSTRUCTIONS
ENGLISH
WARNING
Page 7
Publicidad
