LG WM3250H A Serie Manual De Propietario página 16

16 INSTALLATION INSTRUCTIONS
Leveling fhe washing machine
The washer tub of your new washing machine spins at very
high speeds. To minimize vibration, noise, and unwanted
movement, the floor must be perfectly level and solid.
1
Check the washing machine's level
- Check the precise level by rocking the top edges of
the washing machine or placing a level on the washing
machine The slope beneath the washing machine must
net exceed 1°, and all four leveling feet must rest firmly
on the floor
Level
Turn the lower leveling feet clockwise to level the washing
machine.
- Turning the lower leveling feet clockwise raises the
washing machine
Raise
Turn the Iocknuts counterclockwise and tighten them
when the washing machine is level.
Tighten all 4 lock
nuts securely using
the wrench.
4 Check the washing machine's level again
- Push or rock the top edges of the washing machine
gently to make sure that the washing machine does net
rock
- If the washing machine rocks repeat steps 1 to 3
-A WARNING -,
° Using the washing machine without leveling, it may
result in malfunction caused by the production of excess
vibration and noise,
° If you are installing the washing machine on the optional
pedestal, you must adjust the leveling feet on the
pedestal to level the washing machine, The washing
machine's leveling feet should be minimized and turn the
lecknuts counterclockwise to secure,
• Use the leveling feet only when you level the washing
machine. If you raise the leveling feet unnecessarily, it
may cause abnormal vibration of the washing machine, J
If you install the washing machine on a slippery surface, it may
move because of excessive vibration Incorrect leveling may
cause malfunction through noise and vibration, In the event of
this, lay the non-skid pads under the leveling feet and adjust
the level,
1 Clean the floor to attach the non-skid pads
- Use a dry rag to remove and clean foreign objects or
moisture, If moisture remains, the non-skid pads may slip
2 Adjust the level after placing the washing machine in the
installation area,
3 Place the adhesive side of the non-skid pad on the floor
- It is most effective to install the non-skid pads under the
front legs If it is hard to place the pads under the front
legs, place them under the back legs.
This side up
............ v X
Remove
backing
4 Check the washing machine's level again
- Push or rock the top edges of the washing machine
gently to make sure that the washing machine does not
rock If the washing machine rocks, level the washing
machine again