Publicidad
Idiomas disponibles
Idiomas disponibles
Before You Begin
NOTICE: Measure your product for site preparation. Note the model number located on the bath blower, then visit the
product page at us.kohler.com for more information.
NOTICE: Remote blower installation kit K-1446 is available for relocating the blower.
NOTICE: Provide generous, unrestricted access to the blower. You must provide access for servicing the blower. The
access must be located immediately next to the blower.
NOTICE: Do not lift the bath by the piping or blower, or use the piping or blower for structural support of the bath. To
avoid damage to the bath, lift at the sides of the bath.
NOTICE: Do not support the weight of the bath by the rim. Plan to shim under the bath as needed when leveling the
bath.
NOTICE: Drop-in models are not intended for alcove installation. Use a flanged model for alcove installations.
NOTICE: Drop-in, alcove, or corner installation is possible, depending on the product chosen.
NOTICE: Verify that the flooring offers adequate support for your bath, and verify that the subfloor is flat and level.
NOTICE: This product requires remote blower installation. Refer to the instructions included with the remote blower
kit before proceeding.
NOTICE: Provide adequate ventilation and a minimum 15 cubic feet (.4 cubic meters) of air space in the installed location
for cooling the motor and to supply sufficient air for the blower. Do not install the blower motor closer than 1" (25 mm)
from the wall or other objects.
Carefully unpack and inspect the new bath for damage before installation. If there is damage do not install the bath;
contact your dealer.
1512796-2-A
4
Kohler Co.
Publicidad
