Aiwa NSX-540 Manual De Instrucciones página 24

44 DOWN UP PPI
W,
SETTING THE CLOCK
When you first connect the AC cord, the I SET button flashes to
inform you that the current time needs to be set. Set the time as
follows, while the power is still off.
—_h
Press the If SET button.
The hour flashes.
Press the << DOWN or ®P UP button to
designate the hour.
nN
Press the If SET button to set the hour.
The hour stops flashing and the minute starts flashing.
Press the <<4 DOWN or > UP button to desig-
nate the minute.
o
fe
Press the Ii SET button to set the minute and
complete setting.
a
The minute stops flashing in the display and the clock starts
running from 00 seconds.
To set the time more accurately, press the Il SET button when
another clock or a time signal indicates that the current time is.
00 seconds.
Each colon flash in the display indicates one second.
To correct the current time —
Press the CLOCK button on the remote control. The clock is
displayed and the If SET button on the main unit flashes for 4
seconds.
Within this period, press the Il SET button and continue by
following steps 2 to 5.
To display the current time while the power is on
Press the CLOCK button on the remote control. The current time
is displayed for 4 seconds.
However, the time cannot be displayed, during recording.
To switch to the 24-hour standard
The clock is factory-set to the 12-hour standard. To switch to the
24-hour standard, press the CLOCK button on the remote control
and then press the Il button within 4 seconds. Repeat the samé
procedure to restore the 12-hour standard.
After a power interruption
If you switch the display to clock, the clock flashes to remind you
that the current time needs to be reset.