Aiwa NSX-540 Manual De Instrucciones página 54

2 DOLBY NR
v
REV MODE
EE
u
2) @ REC)
REC MUTE
i
RECORDING
RECORDING FROM THE RADIO OR
CONNECTED EQUIPMENT
Preparation
* Wind up the tape to the point where recording will start.
¢ Use normal (type I) or CrOz (type II) tapes.
-_
Insert the tape to be recorded on into deck 2.
Press the EJECT & mark to open the cassette holder.
Insert the tape with the side to be recorded on first facing you
and the exposed side down.
Push the cassette holder to close it.
Set DOLBY NR.
To record with DOLBY NR: Press the DOLBY NR button to turn
on the DO NR indicator.
To record without DOLBY NR: Press the DOLBY NR button to
turn the indicator off.
N
o
Set the reverse mode.
Each time the REV MODE button is pressed, the reverse mode
changes.
To record on one side only, turn on =.
To record on both sides, turn on =).
Press the TUNER/BAND or VIDEO/AUX button to
select the source to be recorded from and play it.
>
Press the @ REC/REC MUTE button to startrecord-
ing.
When you use the remote control to start recording, first press
the @/O REC/REC MUTE button and then press the <>
button within 2 seconds.
o
To stop recording
Press the Ml button.
To pause recording
Press the Ill button.
To resume recording, press it again.
To insert 4-second blank spaces during recording
A 4-second blank space enables activation of the Music Sensor
function. (See page 42.)
To insert a blank space, press the @ REC/REC MUTE button
during recording or during a recording pause.
RECORD in the display flashes for 4 seconds and the deck pauses.
After 4 seconds, the Ill button flashes. Press itto resume recording.
To insert a blank space of less than 4 seconds
After pressing the @ REC/REC MUTE button, press it again while
RECORD is blinking to resume recording.
To insert a blank space of more than 4 seconds
After the deck enters recording pause mode, press the @ REC/
REC MUTE button again. Eachtime itis pressed, a 4-secondblank
space is added.
If squealing sounds (beating) occur when recording an MW/LW
broadcast, change the FM MODE button to a different position to
eliminate the noise.
Each time the button is pressed, the dot light @ is turned on and off
in the display window. > Eq