Publicidad
Idiomas disponibles
Idiomas disponibles
NAMES OF SIGNAL RECEIVER ON WIRE CONTROLLER
Connecting to the Indoor Unit
Electric Controller Main Board
Signal Receiver
Operation Lamp
Manual Operation Button
INITIAL STATE OF THE WIRE CONTROLLER
When the central controller is connected to the power of the first time, symbols on the LCD will all be on for 2 seconds. Then it auto-
matically shift to CLOCK "00:00", " : " is flashing . The MODE is AUTO, FAN SPEED is AUTO, TEMP. Indicates 24h.
ADJUSTING AIR FLOW DIRECTION
While the unit is in operation, you can adjust the air flow louver to change the flow direction and naturalize the room temperature
evenly. Thus you can enjoy it more comfortably.
(1)
Set the desired air flow direction.
Push the SWING button to adjust the louver to the desired position and push this button again to maintain the louver at this
position.
(2)
Adjust the air flow direction automatically.
Push the SWING button, the louver will swing automatically.
While this function is set, the swing fan of indoor unit runs; otherwise, the swing fan doesn't run. The swing scale of every side is
30º C. When the air conditioner isn't in operation (including when "TIMER ON" is set), the SWING button will be disabled.
AUTOMATIC OPERATION
START
Mode select button (MODE)
Select "AUTO".
Temperature button (TEMP.)
Set the desired temperature. Normally, set it 21º C to 28º C
ON/OFF button
The OPERATION lamp on the display panel lights. The operation mode is selected among COOLING, HEATING (Cooling only type
without) or FAN ONLY operation according to the drop between the room temperature and the set one.The fan speed display will
show AUTO, and the fan speed will not be automatically controlled.
STOP
ON/OFF button
Push this button again to stop the air conditioner and the OPERATION lamp goes off.
Connecting to Wire
Controller
Alarm Lamp
Defrost/ Pre-heat Lamp
Timer Lamp
15
Publicidad
