Publicidad
Idiomas disponibles
Idiomas disponibles
COOLING/DRY/HEATING/ FAN ONLY OPERATION
START
Mode select button (MODE)
Select "COOL", DRY , "HEAT", or "FAN ONLY" mode.
Temperature button (TEMP.)
Set the desired temperature by pushing the button
Cooling:
17 to 30º C
Dry:
17 to 30º C
Heating:
17 to 30º C
Fan Only:
TEMP is not displayed, TEMP. Button is disable.
Fan speed button (FAN SPEED)
Select any one fan speed from "AUTO", "LOW", MED , and "HIGH".Push the button, the fan speed will change on turn as
above.
In the mode of DRY, the fan speed can not be selected; the fan speed will be always on AUTO.
Note: some air conditioners have no MED fan speed.
Confirm button(SET)
Push the button to confirm the current setting.
STOP
ON/OFF button
Push this button again to stop the air conditioner and the OPERATION lamp goes off.
Before you start operating the air conditioner, set the clock of the wire controller using the procedures given in this section. The clock
panel on the wire controller will display the time regardless of whether the air conditioner is in use or not.
INITIAL SETTING
When the wire controller is connected to the power, the clock panel will display "00:00" and the colon will flash.
(1)
Time adjust button (TIME ADJUST)
Push this button to set time.
•
Forward.
Backward.
Each time you push the button, the time moves forward or backward by one minute depending on which side you Push. If
•
you keep on push the button, the number will change 30 minutes/s as your push.
(2)
Confirm button (SET)
When you push the SET button, the clock time display stops flashing and the clock starts operating.
(3)
Readjusting the clock
Push the CLOCK button in the battery compartment, the colon in the clock display will start to flash. To set the new time,
follow 1 and 2 of Initial Setting of the Clock.
Clock accuracy is within 10 seconds per day.
•
Static electricity or other factors (in case of extremely high voltage) can cause the clock of wire controller to re-initialize. If your
wire controller is initialized ( flashing of the colon in "00:00" ), readjust the clock before you start operation.
16
or
.
SETTING THE CLOCK
CAUTION
Publicidad
