Publicidad
Idiomas disponibles
Idiomas disponibles
Connect to Water Supply Pipe and
Power Supply
Connect the water inlet pipe to the
faucet.
The gasket shall be connected to the water
inlet. Please use the new inlet pipe
attached. In order to ensure the quality, all
dishwashers have been injected with water
for testing before leaving the factory.
Therefore, there may be water in the
dishwasher,
which
phenomenon.
Inlet connection
1. The water supply pressure shall be
between 30kPa and 1,000kPa.
2. Do
not
wear
connecting the water inlet pipe with the
valve.
3. If the water supply pressure exceeds
1,000kPa, please install a pressure
reducing device.
4. Turn on the faucet and check the
connector for leakage.
5. Inspect pipes regularly, and change
them if necessary.
6. Ensure that the pipes are not damaged
or intertwined.
Connection between water inlet pipe and
faucet
1. Check the rubber seal on both sides of
the hose. Insert the rubber seal into the
threaded joint of each hose to prevent
leakage.
2. Connect the water supply hose to the
faucet by hand, and then tighten it for
2/3 turn with pliers.
is
a
normal
the
thread
when
3. Turn on the faucet to flush the foreign
matters (dirt, sand or sawdust) in the
water pipe after connecting the water
inlet hose to the faucet. Drain the
water into a bucket and check the
water temperature.
4. Connect the hose to the water inlet
valve tightly by hand, and then tighten
it for 2/3 turn with pliers.
5. Turn on the faucet to check leakage. ln
case of water leakage. please check
steps 1-4.
Connect the power supply
•
Please connect this machine to a
grounding socket according to the
current electrical wiring specifications
and protect it with a circuit breaker or
time—delay fuse of at least 15 Amps.
•
The two-wire system with grounding
must be adopted for wiring.
•
Do not put the power cord behind this
machine, but connect the plug within
1.2m of the side.
83
Publicidad
