Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROL BUTTONS:
GAS CONTROL:
Lighting position
1. LIGHTING INSTRUCTIONS
a.
The heater has three settings. Lighting position (Pos.1) Minimum
position (Pos.2); Medium position (Pos.3) Maximum position (Pos.4).
b. Turn ON the gas
c. With one hand Press down the control button for 10 seconds, at the
same time press down the piezo igniter key with your other hand.
Continue this procedure until pilot is ignited. Release after approx. 20
seconds. If pilot is ignited, it means that the heater is at its minimum
position. If pilot flame goes out, please repeat this procedure.
2. HEAT LEVEL SETTINGS
To change from minimum to medium: Please gently press down the control
button and turn it to position 2.
To change from medium to maximum: Please gently press down the control
button and turn it to position 3.
3. . SWITCHING O
Turn off the gas on the gas cylinder. If the heater will not be used for a period of
time, please disconnect the regulator from the container. If the heater fails to
extinguish, please, move the heater outdoors and disconnect the regulator from
the gas cylinder.
ATTENTION!
Please be sure the control button has been locked when changing form one posi-
tion to another.
STORAGE
1. Disconnect regulator from gas cylinder.
2. Store gas cylinder in a well-ventilated area away from combustible material.
3. The heater should be covered in a dry, dust-free environment.
CLEANING
1. Use a damp cloth wrung out in a solution of soapy water to clean the exterior
and container storage area of your heater.
2. Make sure that no water gets onto the burners or pilot/light area. Wipe the
heater completely dry before use.
3. . Don't use abrasive cleaners as they may damage the quality paint finis
MAINTENANCE
1.Check flexible tube between regulator and heater before every operation and
replace it if worn or damaged.
2. It is recommended that the heater is maintained every two years by autho-
rized personnel.
Minimum position
5
Medium position
Maximum position
V.1
Publicidad
