Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
SYMPTOMS
Pilot will not light
automatically.
Pilot will not light
automatically but points
(a) to (e) are satisfactory
and the pilot will light
with a match.
Heater will not remain
alight when pressure is
released from ignition
button.
After changing to
maximum position with
all three plaques alight.
One or more plaques
appear below normal
intensively.
Difficulty in cross lighting
from position 1 to position
2 or 3.
Smell of combustion.
DISPOSAL: Do not dispose this
product as unsorted municipal
waste. Collection of such waste
separately for special treatment
is necessary.
This product complies with the European ROHS directive (2002/95/EC) on the restriction of
the use of certain hazardous substances in electrical and electronic equipment, transposed
to the Spanish legislation by Royal Decree 208/2005.
FAULT
No spark across
electrode gap.
Incorrect position of
spark in relation to
pilot gas flow.
Electro-magnetic
valve closes whilst
heater is alight.
Blocked jets.
Partially blocked
supply tube.
Air draught
directed away from
first plaque.
Position of the pilot
flame.
Missing piece of
ceramic fireclay.
The european directive 2012/19 /UE on wasted electrical and electronic
equipments (WEEE), requires that household electrical appliances must
not be disposed of in the normal unsorted municipal waste stream.
appliances must be collected separately in order to optimize the
recovery and recycling of the materials they contain, and reduce the
impact on human health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of
your obligation, that when you disposed of the appliances, it must be
separately collected. Consumers should contact their local authority or
retailer for information concerning the correct disposal of their old
appliance.
6
REMEDY
Ensure that piezo-electric
igniter is functioning correctly.
Check that electrical lead is
not damaged.
Re-position spark plug so
that spark jumps across
gas flow.
Ensure that thermocouple
probe is in pilot flame.
Ensure good connection
between thermocouple and
valve.
Check thermocouple.
Check electromagnetic valve.
(by serviceman)
Remove and clean blocked
jet. Remove supply tube,
remove jets and blow
through the tube.
Change the location of the
appliance so that it is not
adversely affected by air
draught. Position pilot so that
flame impinges across bottom
corner of 2nd plaque as well as
1st plaque.
Inspect perimeter of each
plaque and locate place
where some fireclay has been
displaced. Turn to the local
service.
V.1
Publicidad
