KRATOS SAFETY FA 20 103 00A Manual Del Usuario página 7

Chemical products: do not use the device in the event of contact with chemical products, solvents or fuels which could affect its operation.
SUITABILITY FOR USE:
The equipment should be used with a fall arrest system as specified in the data sheet (see standard EN363) to guarantee that the dynamic force exerted
on the user during the arrest of a fall is maxi 6 kN. A fall arrest harness (EN361) is the only body support device that may be used. It may be dangerous
to create one's own fall arrest system where each safety function can interfere with another safety function. Therefore, it is important to read the
recommendations on using each component in the system before use.
VERIFICATION:
Service life of the product is 10 years (in accordance with the annual examination by a competent person authorized by KRATOS SAFETY), but it may
be increased or reduced according to use and/or the results of the annual inspections. The product must be checked systematically in case of doubt or
after a fall and at least every year by the manufacturer or his authorised representative, to guarantee its resistance and thus the safety of the end-user. The
product data sheet should be completed (by writing) after each verification, date of inspection and date of next inspection must be indicated on the data
sheet, it is also recommended to put date of next inspection on the product.
MAINTENANCE AND STORAGE: (these instructions must be strictly respected)
During transportation, keep the equipment away from any sharp edges and in its packaging. Clean with water, wipe with a cloth and hang in a ventilated
room to dry naturally, ensuring that it is away from any direct light or source of heat; the same applies for elements that may have got wet during use.
The system must be stored in its packaging in a dry, well-aired place protected from temperature extremes.
7