Publicidad
Idiomas disponibles
Idiomas disponibles
Step 5. Attach Handle Bar to Lower
Cross Bar Assembly
(Fig. 7)
All the hardware needed for this procedure is in
Bag C.
1. Insert the ends of Handle Bar A into the Link-
age Bars F and G and align the holes of both
bars.
2. Insert two (2) Hex Head Bolts through the
holes of the Handle Bar A and Linkage Bars F
and G. Install one (1) Lock Nut, and use the 5
mm hex wrench and a 13 mm wrench to secure-
ly tighten the hardware until the parts cannot
move freely.
3. To cover the Bolt threads in the Handle area,
place the Rubber Thread Caps on the ends of
the Hex Head Bolts.
Fig. 7
F
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 7
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 7
Assembly
Step 6. Attach Mid Pivot Bar to Wheel
Bar Assembly
(Fig. 8)
All the hardware needed for this procedure is in
Bag E.
1. Insert a Hex Head Bolt through the hole on the
2. Place one (1) Flat Washer on the Hex Head Bolt.
3. Repeat the steps above for the right side of the
Fig. 8
A
G
-7-
left side of the Wheel Bar E, then through one
(1) flat washer, and then through the Mid Pivot
Bar D.
Install one (1) Lock Nut, and use the 5 mm hex
key and a 13 mm wrench to securely tighten the
hardware until the parts cannot move freely.
Then loosen the Nut by 1/8 to 1/4 turn.
Note: To ensure that the joint is not overtight-
ened, ensure that the middle Flat Washer is
able to spin freely.
assembly.
D
E
D
E
4/26/2023 11:32:13 AM
4/26/2023 11:32:13 AM
Publicidad
