Publicidad
Idiomas disponibles
Idiomas disponibles
Step 7. Attach Saw Mounting Bar to
Mid Pivot Bar Assembly
(Fig. 9)
All the hardware needed for this procedure is in
Bag F.
1. Insert a Hex Head Bolt through the hole on
the left side of the Saw Mounting Bar C, then
through one (1) Flat Washer, and then through
the Mid Pivot Bar D.
2. Place one (1) Flat Washer on the Hex Head Bolt.
Install one (1) Lock Nut, and use the 5 mm hex
key and a 13 mm wrench to securely tighten the
hardware until the parts cannot move freely.
Then loosen the Lock Nut by 1/8 to 1/4 turn.
Note: To ensure that the joint is not overtight-
ened, ensure that the middle Flat Washer is
able to spin freely.
3. Repeat the steps above for the right side of the
assembly.
Fig. 9
C
C
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 8
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 8
Assembly
Step 8. Attach Saw Mounting Bar to
Linkage Bar Assembly
(Fig. 10)
All the hardware needed for this procedure is in
Bag E.
1. Insert a Hex Head Bolt through the Left Linkage
2. Place one (1) Flat Washer on the Hex Head Bolt.
3. To cover the Bolt threads in the Handle area,
4. Repeat the steps above for the right side of the
Fig. 10
D
D
-8-
Bar F, then through one (1) Flat Washer, and
then through the Saw Mounting Bar C.
Install one (1) Lock Nut, and use the 5 mm hex
key and a 13 mm wrench to securely tighten the
hardware until the parts cannot move freely.
Then loosen the Lock Nut by 1/8 to 1/4 turn.
Note: To ensure that the joint is not overtight-
ened, ensure that the middle washer is able to
spin freely.
place the Rubber Thread Caps on the ends of
the Hex Head Bolts.
assembly.
C
C
F
F
G
4/26/2023 11:32:14 AM
4/26/2023 11:32:14 AM
Publicidad
