Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
On/Off Button Settings ...................................High/Low/Off
Pre-cut Nichrome Wire (4). ..........9 in. each (229 mm each)
WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, changing tips,
cleaning or when not in use. Removing battery pack will
prevent accidental starting that could cause serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
Do not use any tips or accessories not recommended
by the manufacturer of this product. The use of tips
or accessories not recommended can result in serious
personal injury.
FEATURES
Dual Heat Settings.......................High (520° F), Low (300° F)
ASSEMBLY
WARNING:
Do not attempt to modify this product or create acces-
sories or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to pos-
sible serious personal injury.
OPERATION
APPLICATIONS
WARNING:
Fumes can be hazardous and cause serious injury,
permanent damage or death if inhaled. Follow the foam
manufacturer's safety instructions and guidelines shown
on any labeling, listed in their manual, and/ or on their
SDS sheet. Breathing protection may be required from
the foam manufacturer. This tool is only intended to be
used with polystyrene and polyethylene foams.
You may use this product for the purposes listed below:
Foam cutting, shaping, and shaving
Foam detailed engraving
Foam hole digging
WARNING:
Battery tools are always in operating condition. Remove
the battery pack when the product is not in use or when
carrying at your side.
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 8
WARNING:
To reduce the risk of injury, the foam cutter tip should
be considered to be HOT whenever the LED light on the
unit is illuminated. Following this rule will reduce the risk
of burns, fire, or serious personal injury.
5 — English
Publicidad
