Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING
THE COMPRESSOR
The air compressor
should
be turned off, unplugged
from the power source, the
air bled from the tank and the unit allowed
time to cool before any maintenance
is performed.
Personal
injuries could occur from moving
parts, electrical
sources,
compressed
air or hot surfaces.
The quick connect
assembly
must be attached
before use. Failure to assemble
correctly
could result in leaks and possible
injury.
If unsure of assembly
instructions
or you experience
difficulty
in the assembly
please
call your local service department
for further
information.
2.
3.
Unpack the air compressor.
Inspect
the unit for damage.
If the unit has been
damaged
in transit, contact
the carrier and complete
a damage
claim. Do this i
mmediately
because
there are time limitations
to damage
claims.
Check the compressor's
serial label to ensure that you have received
the model
ordered,
and that it has the required
pressure
rating for its intended
use.
Locate the compressor
according
to the following
guidelines:
a.
Position
the compressor
near a grounded
electrical
outlet.
b.
The compressor
must be at least 12 inches (31 cm) from any wall or
obstruction,
in a clean, well-ventilated
area, to ensure sufficient
air flow and
cooling.
c.
In cold climates,
store portable
compressors
in a heated
building
when
not in use. This will reduce problems
with motor starting and freezing of
water condensation.
d.
Remove the compressor
from the carton
and place it on the floor or a hard,
level surface.
The compressor
must be level to ensure proper drainage
of
the moisture
in the tank.
12- ENG
Publicidad
