Kübler CODIX 533 Manual De Instrucciones página 20

2.1 Intended Purpose
This device shall only be operated
as a built-in device. Its fields of appli-
cation are industrial processes and
controls for manufacturing lines in
the metal, wood, plastic, paper, glass
and textile industry, and similar appli-
cations.
Overvoltages at the screw terminals
of the device must be limited at the
values of the overvoltage category II.
3 Start-up
After powering the device, the following
message is displayed for 2 seconds:
Then the device type is displayed for
2 seconds, followed by the software
version, also for 2 seconds. After
reading the EEPROM, the device
switches to the operating mode.
3.1. Reset, Back to Factory Setting
Press both keys simultaneously and
power the device: the following mes-
sage appears on the display:
The device is reset to the factory
settings and is now ready for opera-
tion.
4
If the device is used for monitoring
machines or process flows, in which
a breakdown of the device or an
operating mistake might lead to
machine damages or operator acci-
dents, the user must take suitable
safety measures.
3.2. Programming and Operation of
the Setpoint Generator With the
2 Keys
⇑
⇑
While programming, press both keys
simultaneously to switch over to the
following parameter.
Within a parameter, confirm an input
also by pressing both keys.
⇑
The right key allows selecting the
values of the parameters. To input a
numerical value, select the decade
with the left key
⇑
and select a value between 0 ... 9
⇑
with the right key.