Kübler CODIX 533 Manual De Instrucciones página 25

2. Functions
– SPecial display func-
tion, see 4.2.3.1
– SiGnal allows selecting
the setpoint output in volts or mA.
– time allows selecting
the time unit in seconds or minutes.
– Number of PEriods
allows defining the number of refer-
ence points.
– output 1 allows select-
ing the current or voltage value for
the first reference point.
– PEriod. 1 allows defin-
ing the duration of the first period.
(A maximum of 20 periods may be
programmed) The maximum set-
points ou. X and the times PE. X
result from the setting of PEr.
– The function cYcle
allows defining the number of cycles
to be carried out.
If cYcle = 0,
played automatically after 1 second.
noCYcle will start an endless loop.
Press both keys simultaneously to
switch over to the following parameter.
Within a parameter, select the decade
with the left key and select a value
from 0 ... 9 with the right key.
3. After setting the value of cYcl,
press both keys simultaneously;
the following message is displayed:
4. Use the right key to select YES or
no
5. If YES is selected, press both
keys simultaneously to end the
programming
6. The device is now ready for
operation. Press the right key to
start it and the left key to stop it.
Note:
After powering, the device outputs
0.00 mA or 0.00 V. The Auto function
is dis-
does not start automatically.
Alter the manual start of the Auto
function, the device outputs the
value ou.1. After the execution of the
cycle, the output remains with the
value ou.1.
⇑
⇑ ⇑
9