Publicidad
Idiomas disponibles
Idiomas disponibles
iNSTALLING AND REMOVING ATTACHMENTS - FIGURE G
_WARNING:
Shock hazard. Under no circumstances should
this product be used near water.
_WARNING:
Burn hazard. Moving parts within the Power
Unit become hot during use. Avoid contact with moving parts
within Power Unit when removing and installing accessories.
z_WARNING:
Before assembly, lock the Power Unit by
setting the forward/reverse
slider (7) to the center position and
remove the battery from the Power Unit. Remove any accessory
from the attachment before removing or installing the attachment.
z_WARNING:
To reduce the risk of injury, do not place fingers or other objects inside the
Power Unit, other than the attachments designed to work with the Power Unit.
Lock the Power Unit by setting the forward/reverse
slider (7) to the center position.
To remove an attachment, depress the release button (9) and take the attachment off the toot.
To fit an attachment, line it up with the tool as shown and push it onto the Power Unit until it snaps
into place and an audible click is heard.
Ensure attachment is securely attached by gently pulling it away from the Power Unit.
NOTE: Only use attachments that are specifically designed for and compatible with the
Power Unit.
NOTE: Refer to individual attachment instruction manuals for specific safety warnings and
operating instructions before operating attachments with the Power Unit.
OPERATING:
DRILL/SCREWDRIVER
ATTACHMENT
SAFETY WARNINGS
AND INSTRUCTIONS:
DRILLS
1. Hold drill firmly with one hand on the grip and the other hand on the bottom of the battery pack unless
an auxiliary handle has been supplied with the tool. Use auxiliary handle if supplied with the tool.
2. When attaching accessories
in the drill chuck, hand tighten the keyless chuck firmly.
z_WARNING:
Drill may stall (if overloaded or improperly used) causing a twist. Always expect
the stall. Grip the drill firmly with both hands to control the twisting action and prevent loss of
control which could cause personal injury. If a stall does occur, release the trigger immediately
and determine the reason for the stall before re-starting.
z_WARNING:
Let the tool work at its own pace. Do not overload.
ZLWARNING:
Before drilling into walls, floors or ceilings, check for the location of wiring and pipes.
FITTING AND REMOVING
A DRILL BIT OR SCREWDRIVER
BIT
The drill/screwdriver attachment (11) is fitted with a keyless chuck (12) to allow for an easy exchange of bits.
Lock the toot by setting the forward/reverse
slider (7) to the center position.
Open the chuck by turning the front part clockwise with one hand while holding the rear part
with the other.
Insert the bit shaft into the chuck.
Firmly tighten the chuck by turning the front part counterclockwise.
To remove the screwdriver bit from the holder, lift the bit from the recess.
To store the screwdriver bit, firmly push it into the holder (10).
SCREW DRIVING
Always use the correct type and size of screwdriver bit.
If screws are difficult to tighten, try applying a small amount of washing liquid or soap as a lubricant.
Always hold the tool and screwdriver bit in a straight line with the screw.
For driving fasteners, the reversing button should be pushed to the left. Use reverse (button
pushed to the right) for removing fasteners. When moving from forward to reverse, or vice
versa, always release the trigger switch first.
lO
Publicidad
