Jimmy BX5 Pro Manual Del Usuario página 7

5. Cut off power when machine is under cleaning, repairing or is not used.
6. Keep the power cord away from sharp objects and do not drag the cord to move the
machine in case of cord damage.
7.For safety reasons, please do not use the product to clean hot objects such as carbon,
cigarette butts, sharp objects such as broken glass, corrosive liquids, flammable and explosive
materials such as gasoline and alcohol. Otherwise it may cause product damage or fire.
8.Do not use this machine to pick up water or wet dust, and avoid the machine from being
exposed to rain, water or being used in wet places (such as bathrooms, washrooms, laundry
rooms, etc.) to avoid failure.
9. Avoid the product approaching heating appliances or being exposed to the sun to avoid fire.
10. Do not lezt children play with or operate the product to avoid accidents.
11. Avoid product running for a long time when the suction port is blocked to avoid damage.
12.The product is equipped with UV light.Do not view the bottom of the machine when the
power is turned on to prevent UV rays from causing harm to human body.
13.Please do not let UV light shine on plants to avoid damaging them. Do not concentrate UV
light in one place for continuous use, which may cause damage to the cleaned objects.
14. Do not sit on the product to avoid damage.
15. Do not remove brushroll when machine is powered on or running to avoid damage.
16. This product can only use for cleaning of textiles such as mattresses, blankets, pillows,
sofas, etc.
17. If there is damage on power cord, to avoid danger, it should be replaced or repaired by
manufacturer,repairing agency or professional person.
Trouble Shooting
Please check the following trouble points before go to the maintenance department.
Problems Possible Reasons
Power cord is not firmly inserted
Product does
No power on socket
not turn on
On/off switch is not pressed down
Air inlet blocked
Weak suction MIF filter blocked
Cyclone blocked
Machine tilt and micro switch left
cleaning surface
UV light does
UV light defect
not work
Micros witch damaged
Solution
Insert the power cord firmly
Check the socket
Press the On/Off button
Clean up suction port
Clean up the dust cup and filter
Clean cyclone
Machine tilting degree cannot ex-
ceed 30 degree
Contact after service to replace UV
light
C o n t a c t a f t e r - s a l e s e r v i c e t o
replace micro switch
5