NeuLog WIFI-202 Guia Del Usuario página 22

1. Connect either a BAT-200 or a USB to micro USB
cable connected to a power source, to the WIFI-202
module to supply power.
2. The WIFI-202 indicator lights will flash; take no action
until the LED to the far left turns blue.
3. Take your tablet or smart phone and go to the WiFi
settings and select the NeuLog network which
matches the WIFI module ID found on the back of the
WIFI-202 device (NeuLog1334 for example).
4. Once the device is connected go to your browser
and type in the website wifi201.com into the URL bar,
then wait for 30-60 seconds.
Note: Only one device can be in control mode at a
time, the remaining devices must be in "View mode"
but switching between them is both possible and
very easy. The "Control mode" allows the user to
change experimental parameters and both start and
stop data collection. View mode allows the user to
view the data being recorded.
5. The browser will then load a new screen and begin to
auto detect the sensors, this can take a minute.
6. Once the sensors are found you will see an icon on
the left side of the screen for any detected sensors.
The icon will display data in real time.
7. To set the sensors' settings click on each sensor's
icon.
V2018.01
22
Home
English