NeuLog WIFI-202 Guia Del Usuario página 25

Using the WIFI-202 in USB mode
USB mode allows you to use your WIFI module as if it
were a NeuLog USB-200. This requires a computer
which has the NeuLog software (available as a free
download on www.NeuLog.com).
By connecting the WIFI module to your sensors and
computer via the included USB to micro USB cable, you
are able to stream data directly from your sensors to the
NeuLog browser based application.
To enter USB Mode:
1. Download and install the NeuLog browser based
application onto the computer which you plan on
using. The application can be downloaded for free at
www.NeuLog.com
guide.
2. Choose "Downloads" on the main menu and then
choose "Software and Application".
3. Connect the WIFI module to the computer with the
NeuLog application using the included USB to micro
USB cable, you'll see the LED lights blink for a
moment while the module powers on.
4. Connect your NeuLog sensors to the side of the WIFI
module, the red LED on each sensor should blink to
acknowledge they are working properly.
V2018.01
25
as well as a full application user
Home
English