NeuLog WIFI-202 Guia Del Usuario página 26

5. Press the button located on the front panel of the
WIFI module three times, the yellow LED labeled 'U'
should turn on.
6. Open the NeuLog application.
7. Your connected sensors will automatically be
detected.
8. Once your sensors are detected, you can begin
experimenting in USB mode!
Note: To switch back to Access Point mode from
USB mode, press the button on the WIFI module
faceplate three times again.
Troubleshooting walkthrough
Due to the technological complexity of the NeuLog WIFI-
202 module and the ever updating software and
hardware found on today's wireless devices, it is possible
that you may run into some performance issues while
the unit is communicating with your wireless device.
Luckily, for these circumstances the NeuLog WIFI
module can easily be cleared and updated!
If you are noticing that the performance of your NeuLog
WIFI-202 module is acting sporadic please follow the
guides below.
V2018.01
26
Home
English