Princess TURBO FRYER 180710 Instrucciones De Uso página 9

- Clean both inside and outside the fryer regularly.
- Regularly clean the outside of the fryer with a damp cloth and dry it with a soft, clean towel.
- Do not use abrasive detergents.
- When replacing the oil, you can also clean the inside of the fryer. Empty the fryer and first clean the inside
with a paper towel and then wipe with a wet cloth dipped in soapy water. Then wipe the inside with a damp
cloth and allow it to dry.
PRINCESS TIPS
- While heating up and frying, do not keep the lid on the appliance to prevent condensation.
- Always place the fryer on a stable surface and keep flammable materials away.
- Do not place the fryer on or near a switched-on hot plate.
- Bef ore you use the fryer it must be filled with the required amount of fat or oil. Never use the fryer without
oil or fat as this will break the appliance.
- Never move the appliance during use. The oil becomes hot and you can burn yourself. Wait until the oil has
cooled down before moving the fryer.
- Never immerse the appliance in water!
- Do not leave the appliance unattended while in use. Close supervision is necessary when the fryer is used
near children.
- Do not use the appliance if the cord is damaged. Send it to our service department to minimise any risk. With
this type of appliance, a damaged cord should only be replaced by our service department using special tools.
- Make sure the thin pipes running along the heating element are not damaged (do not dent or bend).
- The electrical part comes complete with a safety switch which ensures that the heating element can only
operate when the element is correctly positioned in the pan.
- Never use previously defrosted and subsequently refrozen products. These contain a lot of water which will
cause excessive spattering.
- Children should be supervised to ensure that they do not play with the appliance.
- The use of this appliance by children or persons with a physical, sensory, mental or motorial disability, or
lack of experience and knowledge can give cause to hazards. Persons responsible for their safety should give
explicit instructions or supervise the use of the appliance.
In the case of overheating, the pan will switch off auto-matically.
This safety mechanism can be found on the bottom of the
electrical part. If its switches off, it can be reactivated by pressing
in the button with a long pointed object. The button is situated
deep behind the hole and you should use the restart pin supplied.
First remove the plug from the socket.
U.K. WIRING INSTRUCTIONS
The wires in the mains lead are coloured in accordance with the
following code:
BLUE
BROWN
GREEN/YELLOW EARTH
As the colours of the wire in the mains lead of this appliance may not correspond with the colour markings
identifying the terminals on your plug, proceed as follows:
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or
coloured black.
The wire which is coloured BROWN must be connected to the terminal which is marked
with the letter L or coloured red.
The wire which is coloured GREEN/YELLOW must be connected to the terminal which is
marked with the letter E or
If a 13Amp (BS1363) plug is used, a 13Amp (BS1362) fuse must be fitted, or if any other
type of plug is used, a 13Amp fuse must be fitted, either in the plug or adaptor, or on the
Distribution Board.
WARNING: THIS APPLIANCE MUST BE EARTHED
NEUTRAL
LIVE
and is coloured GREEN or GREEN/YELLOW
9