Makita RP1800 Manual De Instrucciones página 8

guide cannot be used. In this case, firmly clamp a
straight board to the workpiece and use it as a guide
against the trimmer base. Feed the tool in the direction
of the arrow.
009861
Templet guide (optional accessory)
009862
The templet guide provides a sleeve through which the
bit passes, allowing use of the tool with templet patterns.
To install the templet guide, pull the lock plate lever and
insert the templet guide.
1
2
009863
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
5
6
003695
1. Template guide
2. Lock plate
1. Bit
7
2. Base
3. Templet
4. Workpiece
5. Distance (X)
6. Outside
diameter of the
templet guide
7. Templet guide
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by using
the following equation:
Distance (X) = (outside diameter of the templet
guide - bit diameter) / 2
Trimmer guide (optional accessory)
009867
Trimming, curved cuts in veneers for furniture and the
like can be done easily with the trimmer guide. The
guide roller rides the curve and assures a fine cut.
Install the trimmer guide on the guide holder with the
clamping screw (B). Insert the guide holder into the holes
in the tool base and tighten the clamping screw (A). To
adjust the distance between the bit and the trimmer guide,
loosen the clamping screw (B) and turn the fine adjusting
screw (1.5 mm or 1/16" per turn). When adjusting the
guide roller up or down, loosen the clamping screw (C).
After adjusting, tighten all the clamping screws securely.
1
2
3 4
009868
When cutting, move the tool with the guide roller riding
the side of the workpiece.
3
003701
8
1. Guide holder
2. Adjusting screw
3. Clamping screw
6
(B)
4. Clamping screw
(C)
5. Trimmer guide
6. Clamping screw
(A)
5
1. Bit
1
2. Guide roller
3. Workpiece
2