Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Replacement LED Bulbs are available for SOL Spout Lights. To loosen and tighten the brass lens
ring on SOL Spout Lights, use the included key. Simply place the key in the slots on the brass lens
ring to loosen or tighten. Ensure that all components are installed correctly after servicing. Inspect
the silicone gaskets for defects and proper placement before re-assembling. Ensure that the lens
ring is tightly secured before submersing the fixture.
SOLWSL2
HARDSCAPE LIGHTS - SOLWH06 / SOLWH12
Installation
Hardscape Wall Lights are designed to be installed into walls and columns, just under the
capstone. The LED light strip and driver can be replaced without removing the capstone.
The cord between the driver connection and the
light is approximately 19' , enabling the driver to be
left outside of the column or wall for future access.
When laying the base course of stone, either notch
the cord into the wall or leave a notch slightly larger
than ¾" to pass the cord through. If multiple lights
are going to be installed, the notch will need to be
slightly larger to accommodate multiple cords.
When installing the mounting bracket, make
sure to notch the stone for the ¼"cord. Test fit the
mounting bracket and cord, so that it does not rock
or put too much pressure on the cord. The holes in
Driver
the bracket are for glue points to hold the capstone
and bracket in place.
NOTE: The Hardscape Lights are not submersible.
4
Publicidad
