Publicidad
Idiomas disponibles
Idiomas disponibles
Warranty
All Atlantic SOL Warm White Lighting carries a five-year limited warranty.
All SOL Wiring Components carry a five-year limited warranty.
Atlantic SOLTRANS88 carries a one-year limited warranty.
This limited warranty is extended solely to the original purchaser commencing from the date
on the original purchase receipt and is void if any of the following apply:
• The cord has been cut or altered between the driver and the light body.
• The light body / LED components have been misused or abused.
• The light body / LED components have been disassembled or modified other than as
described in this manual.
This warranty excludes labor / cost of labor for removal or installation of any product.
Troubleshooting Guide
Always turn off power before inspecting the SOL lights. Failure to observe this precaution can
result in a serious accident.
Before ordering repairs, carefully read through this instruction booklet. If the problem persists,
contact your dealer.
Problem
Lights will
not turn on
Lights will
not turn off
Individual
lights within
a larger
system not
working
Possible Cause
No input power to
the transfomer
No outlet power from
the transformer
Photocell malfunction
Timer control
Photo cell is covered
Defective 4-way
splitter
Loose connection
Moisture or corrosion
in connections
Failed Driver
Failed LED diode/
lamp
Possible Solution
Verify power to the outlet is on / Check GFCI
reset
Check the reset button / circuit breaker on the
transformer
Verify if the transformer is operational by
moving the timer to the ON position
Use a volt meter to verify transformer is
producing 12 volt AC
Cover the photocell with a piece of dark tape to
check function
Make sure timer control is not set to the ON position
Clean sensor and outer clear covering
Make sure nothing is shading the sensor
Switch positions with a working light on the same
splitter to identify if the splitter is causing the issue.
Inspect quick-connected plugs for moisture,
corrosion or missing gasket.
Clean/ dry and reassemble.
If possible, switch out driver with one from a
working light of the same model to determine if
the driver has failed.
Replacement drivers are available.
If possible, switch out the LED diode/ lamp with
one from a working light of the same model to
determine if the driver has failed.
Replacement LED diodes/ lamps are available.
7
Publicidad
