7. Cleaning, maintenance and
ordering of spare parts
Danger!
Turn off and remove the rechargeable battery
from the hedge trimmer, before putting down or
cleaning.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
•
Remove deposits from the guard hood with a
brush.
7.2 Maintenance
•
The cutters should be cleaned and lubricated
at regular intervals in order to ensure best
performance at all times. Remove deposits
with a brush and apply a thin film of oil (Figure
11).
•
There are no parts inside the equipment
which require additional maintenance.
•
For storage, the hedge trimmer can be hung
up on a nail, screw or similar in a borehole on
the impact guard, with blade guard mounted
(Fig. 12)
7.3 Storage
•
For storage, the hedge trimmer can be hung
up on a nail, screw or similar in a borehole on
the impact guard, with blade guard mounted
(Fig. 12)
7.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Anl_GC_CH_1846_Li_SPK13.indb 18
Anl_GC_CH_1846_Li_SPK13.indb 18
GB
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
8. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
•
Remove the rechargeable battery/batteries.
•
Clean and maintain the equipment before
putting it into storage
•
Store the equipment and accessories in a
dark and dry place at above freezing tem-
perature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in
its original packaging.
•
Use the cutter rail guard
10. Transport
Remove the rechargeable battery/batteries.
Secure the equipment during transportation in or-
der to prevent damage or injuries. Use the cutter
rail guard.
11. Faults
The device does not operate:
Check whether the rechargeable battery is char-
ged and whether the battery charger works. If
the device still does not work even with a voltage
supply, please send it to our customer services
department at the address indicated.
- 18 -
27.09.2023 08:30:44
27.09.2023 08:30:44