Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
6
Wiring the fan to the receiver
NOTE: The fan comes with 8 in. lead wires for use with the
provided 6 in. ball downrod assembly (B). If you wish to
use longer downrod, you can use the extension lead wire
(42 in.) (J) or (M) provided.
□
If using the 6 in. ball downrod assembly (B) provided, wire the
receiver to the fan wires by connecting the molded adaptor
plug from receiver (H) with molded adaptor of the fan motor
assembly (E) together.
□
If you wish to use longer downrod, you can use the extension
lead wire (42 in.) (J) or (M) provided by connecting the molded
adaptor together.
Red
Black
White
H
Outlet box
Green
Receiver
Antenna
J
7
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod
mounting, the tab in the ring at the bottom of the
mounting bracket must rest in the groove of the hanger
ball. Failure to properly seat the tab in the groove could
cause damage to the wiring.
NOTE: The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
□
Align the locking slots of the canopy (C) with the two screws (II)
and alignment post (KK) in the mounting bracket (A).
□
Push up the canopy (C) and turn clockwise until the alignment
post (KK) engage to the round hole and the screws (HH) engage
to the key slots.
□
Firmly tighten the two mounting screws (II).
□
Align the oval shape on the canopy (C) with canopy bottom cover
(JJ), Push up the canopy bottom cover (JJ) until the screw (II)
heads engage to the slots on the canopy bottom cover (JJ) so
that the magnetic canopy bottom cover (JJ) can be attached to
the bottom of the canopy (C) properly.
M
10
KK
A
II
C
JJ
D
E
Publicidad
