Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Mounting the remote wall cradle
NOTE: The remote wall cradle is designed to allow you to
access an existing switch. The remote wall cradle can be
mounted on the wall or to the face plate of a standard toggle
switch or a paddle switch. Follow the instructions below for the
option that best suits your needs.
1a. Attaching over a standard toggle switch
□
Remove the two screws from the toggle switch face plate.
□
Place the toggle switch spacer over the toggle switch face
plate and align the two large holes of the toggle switch spacer
with the holes in the face plate. Secure the toggle switch
spacer to the face plate using the two included machine
screws (FF).
□
Attach the remote wall cradle (L) to the toggle switch spacer
using the included two short tapered screws (GG). Screw a
short tapered screw (GG) into the top hole and bottom hole of
the wall cradle and into the toggle switch spacer until tight.
1b. Attaching over a paddle switch
□
Remove the two screws from the paddle switch face plate.
□
Place the remote wall cradle (L) over the paddle switch and align
the two holes of the remote wall cradle (L) with the holes in the
face plate. Secure the remote wall cradle (L) to the face plate
using the two included machine screws (FF).
1c. Attaching to the wall
NOTE: Screw wall anchors are included for extra support. The
included screws are designed to screw easily into the wall. If
you would like a more permanent or secure hold, install the wall
anchors prior to attaching the wall cradle to the wall.
□
Position the remote wall cradle (L) in the desired position
and attach to the wall using the included two long tapered
screws (HH).
Toggle switch face plate
Toggle switch spacer
Paddle switch face plate
HH
HH
14
FF
GG
L
FF
L
L
Publicidad
