HAMPTON BAY TITAN 52401 Guía De Uso Y Mantenimiento página 8

Assembly - Hanging the Fan
1
Attaching the fan to the electrical box
WARNING: To reduce the risk of fire, electric shock or
personal injury, mount to an outlet box marked "Acceptable
for fan support of 35 lbs. (15.9 kg) or less," and use the
screws provided with the outlet box.
NOTE: The mounting bracket (A) is designed to slide into
place on an outlet box with the outlet box screws (MM).
□
Pass the 120-Volt supply wires through the center hole in the
slide-on mounting bracket (A).
□
Install the slide-on mounting bracket (A) on the outlet box by
sliding the slide-on mounting bracket (A) over the two screws
(MM) provided with the outlet box. If necessary, use leveling
washers (not included) between the slide-on mounting bracket
(A) and the outlet box. The flat side of the slide-on mounting
bracket (A) should face toward the outlet box, as shown.
□
Securely tighten the two mounting screws (MM).
2
Install the blade to the
motor assembly
□
Attach a blade (G) to the motor assembly by aligning the holes
on the blade (G) with the holes on top and bottom of motor
assembly, inserting the two screws (AA) into the holes in
the top of blade (G) and through the top of motor assembly,
inserting the three screws (BB) into the holes in the bottom of
blade (G) and through the bottom of motor assembly.
□
Tighten each screw to secure the blade (G).
□
Repeat this step for each blade (G) and blade arm on motor
assembly.
3
Hanging the fan
□
Carefully lift the fan-motor assembly (E) up to the slide-on
mounting bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the mounting bracket socket. Ensure that the tab on the
slide-on mounting bracket (A) socket is properly seated in the
groove in the hanger ball of the ball/downrod assembly (B).
E
8
AA
G
BB
A
B
C
JJ
D
E