Program Function; Accessories Included - ELICA Marie Manual De Instrucciones

PROGRAM FUNCTION

When the ON/OFF button is set to ON, the Power indicator turns BLUE. On touching the
Function button for the first time the WHITE light comes on. The program will start and function
as follows: 10 min ON – 10 min pause – 10 min ON – 10 min pause, running for a total of 360 min,
then stops. Unit returns to standby. On touching the Function button for a second time, the BLUE
light comes on. The program will start and function as follows: 60 min ON – Stop. Unit returns to
standby. Touch the Function Button for the third time: the function is switched completely OFF.
The unit is now in standby.
RE-CHARGING INSTRUCTIONS
This unit is powered by a rechargeable Li-ion battery. It can be re-charged either using the USB
port on your computer or the USB power adaptor, with a rated output of DC 5V ~ 1A.
CHARGING THE BATTERY FOR THE FIRST TIME
- Charge the Li-ion battery for a minimum of 4 hours prior to first use.
- The Power indicator will be RED while charging in the power OFF Mode. When the red light
turns OFF, the unit is fully charged.
When the battery level falls to below 20% of its full charge the LED button turns ORANGE,
alerting you to re-charge the battery as soon as possible. Plug the unit into a USB port on your
computer, or into the USB power adaptor (included), using the USB cable (included). Disconnect
the USB cable from the unit as soon as it is full charged.
Charging in Power ON mode
- The Power indicator LED will be PINK when charging in the Power ON mode. When the light
turns BLUE, this means the unit is fully charged.
Charging in Power OFF mode
- The Power indicator will be RED while charging.
- When the RED light turns off, this means the unit is fully charged.
To save energy and ensure long capsule life, we recommend intermittent use of max. 120 minutes
and leaving the device on stand-by overnight.
HOW TO USE YOUR MARIE UNIT
B.
A.
C.
Press the ON/OFF (1) button to switch on the device. The power indicator (3) will turn Blue.
A) Open the upper grid (6) by pressing the open grid button (8).
B) Place one capsule in the tray (7).
C) Remember to place the capsules bottom side down (see figure).
Close the tray by pushing it gently until it clicks shut. Now you can select one of the two operating
models. Press the function button (4) at the front of the unit to do this.
USING THE REMOTE CONTROL
The remote control has three buttons:
Press the button for the first time, the first program starts. A WHITE
light appears on the diffuser.
Press the button a second time, the second program starts. A BLUE
light appears on the diffuser.
Press the button a third time, the diffuser returns in standby mode.
Press the button for the first time, the first program starts. A WHITE
light appears on the diffuser.
Press the button a second time, the second program starts. A BLUE
light appears on the diffuser.
How to insert/remove the remote control battery:
Press where indicated by the arrow and pull the battery tray out.

ACCESSORIES INCLUDED

Carefully remove the unit and all the accessories from the gift box. Please make sure that you
have all the following accessories before recycling the gift box.
- 3.7V-1000mAh Li-ion Rechargeable Battery
- USB cable for charging Li-ion Battery
- USB adaptor + plugs
- User manual