Bixpy PP-768 Manual Del Usuario página 6

MATING YOUR PP-768 TO YOUR BIXPY MOTOR
The first few times you connect your device the connectors are more difficult to mate until they are "broken-in". DO
NOT use force pliers or other tools to mate your connectors. Be patient and use a towel for better grip if
necessary. Over-tightening the connectors will NOT provide a better water seal and broken connectors are not
covered under warranty.
In general it is a good idea to fill your connectors with dielectric grease before mating especially if you use your
equipment in or near salt water.
The connector caps on your Power Pack housing and adapter wires are there to protect your connectors during
storage and transportation. Remove the caps that will be submerged or they will come off and be lost with water
flow. The connector cap on your charging and main power output ports must be installed tightly at all times when
near water. NOTE: Never cap and store a wet connector!
Page 5