Bixpy PP-768 Manual Del Usuario página 8

SYNCING YOUR REMOTE TO YOUR POWER PACK
If syncing is successful you will hear a series of beeps from your battery on the last button press. If not remove the
kill switch wait 10 seconds and try again.
The Bixpy Remote control is equipped with a watch battery CR2032 which is a readily available battery on-line or
at many retail stores. If the red LED light on your remote is very weak or not lighting up when you press buttons
you will need to replace the battery. Please visit www.bixpy.com/guides for instructions on how to replace your
remote battery.
Your remote is mated to your PP-768 using Bluetooth technology. Only
Bixpy Remotes with the Bluetooth logo will be able to sync to your PP-768.
Older Bixpy Remotes will not sync to your PP-768.
To check whether your Remote and Power Pack are already synced
activate your Power Pack using your kill switch. Then press the stop button
only. If you hear a series of beeps then your remote is already synced to
your Power Pack.
To sync your remote to your Power Pack activate your Power Pack using
your kill switch. Within 20 seconds after you activate your Power Pack
follow the key sequence below:
Press Stop 3 times
Press Forward 1 time
Press Reverse 1 time
Press Stop 1 time
Page 7