SEVERIN CY 7103 Instrucciones De Uso página 16

∙ Let the pleated filter dry for about 3 days.
∙ When the parts are completely dry, place the strainer onto the pleated filter.
filter must be aligned. Check that they are firmly seated.
Assemble the dust container
∙ While holding the dust container lid by its handle (14), place the motor pre-filter on the bottom of the lid, turn the base
towards and lock it in place.
∙ Replace the dust container lid on the dust container (ensure
and lock it in place.
∙ Fit the dust container (7) into the appliance and lock it in place.
EPA filter:
∙ Clean the filter regularly, particularly under the following conditions:
∙ if the suction power seems to be reduced
∙ before storing the appliance for an extended period, or
∙ before sending to the service centre.
∙ When normally used for household purposes, the filter should be replaced every 6 months.
∙ Open the EPA filter cover (9) and take the filter out.
∙ First tap out the filter and then brush it out. Then tap out any loosened dust residues again.
∙ The EPA filter is not washable.
∙ Put the filter back in and close the cover.
Cleaning
∙ The housing and power cable may not be handled with liquids or immersed in liquids for reasons of electrical safety. Rub
housing with a slightly damp cloth and then dry.
∙ For cleaning, do not use any sharp or scouring cleansers or hard brushes.
Storing the appliance
∙ When not in use, the floor nozzle can be hooked into the park hook holder (10) above the cover of the EPA filter.
Troubleshooting by yourself
∙ To avoid any problems, it is important to empty the dust container regularly and to take this opportunity to check the filters
and clean or replace them depending on how dirty they are.
∙ Before contacting our customer service, check with the help of below table whether you can correct the problem yourself.
16
on the strainer and
is aligned with ), then turn the handle (14) towards
on the pleated