Celexon CLR HomeCinema UST Manual De Usuario página 19

7. Fix the frame by screwing the four screws (Q) into each L-Bracket. Make
sure that as soon as one bracket is fi xed you do the diagonally opposite
bracket next.
Fig 7.
8. Insert the support strut (L) to
the centre of the length of the
frame (according to fi g. 8) and
fi x it with the screws (P) to the
connecting bracket (I).
9. Carefully turn the assembled frame over with 2 people, so that the
connecting brackets (J) are on top. Screw the screws (O) into the
connecting brackets and tighten them. Make sure that you always tigh-
ten the opposite side fi rst. Then tighten the screws on the inside with the
Allen key (S)
Fig 9.
Please note: During the last frame assembly steps, it must be ensured
that all frame parts are mitred to fi t and tightened. If there are small
gaps in the mitre, the cover frame cannot fi t fl ush and unsightly joints
will appear in the frame corners. As soon as you fi nd small gaps in the
mitre, loosen all fasteners and connecting brackets, push the frame
parts together and gradually re-tighten the loosened components.
Fig 8.
6