Important Safety Instructions - Hayward RC34 Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 43
This robotic swimming pool cleaner has been manufactured with the highest degree of care and concern
for safety. We suggest the following safety precautions become part of your pool safety regulations:
1. ⚠ WARNING - TO REDUCE THE RISK OF INJURY, DO NOT PERMIT CHILDREN TO USE THIS PRODUCT UNLESS
THEY ARE CLOSELY SUPERVISED AT ALL TIMES.
2. ALWAYS REMOVE THE CLEANER COMPLETELY FROM THE POOL PRIOR TO ENTERING THE POOL.
ALWAYS STAY OUT OF THE POOL WHILE CLEANER IS IN OPERATION.
3. ALWAYS PUT THE MACHINE INTO THE WATER BEFORE CONNECTING IT TO THE RCD PROTECTED ELECTRICAL
OUTLET.
4. BE CERTAIN THE MACHINE IS ONLY PLUGGED INTO A PROTECTED 230 V OUTLET THAT IS PROTECTED
FROM SHORT-CIRCUITS. FIT A 30 mA DIFFERENTIAL PROTECTION DEVICE TO PROTECT PEOPLE FROM
ELECTRIC SHOCK CAUSED BY A POSSIBLE BREAK IN THE ELECTRICAL INSULATION.
5. DO NOT USE AN EXTENSION CORD. THIS COULD CREATE A SAFETY HAZARD AND/OR DAMAGE YOUR CLEANER.
6. DO NOT HANDLE MACHINE WHILE IT IS PLUGGED INTO THE ELECTRICAL OUTLET.
7. NEVER ALLOW PLUG TO ENTER THE POOL.
8. DO NOT OPERATE THE MACHINE OUT OF WATER. THIS WILL DAMAGE THE MOTOR SEAL AND VOID THE
WARRANTY.
9. DO NOT DRAG THE MACHINE OUT OF THE POOL AGAINST THE SIDE WALL. THIS COULD DAMAGE UNIT AND/OR
YOUR POOL WALL.
10. DO NOT BURY CORD. DO NOT OPERATE CLEANER WITH DAMAGED CORD. REPLACE DAMAGED CORDS
IMMEDIATELY.
11. IF THE SUPPLY CORD IS DAMAGED IT MUST BE REPLACED BY THE MANUFACTURER, SERVICE AGENT, OR
SIMILARLY QUALIFIED PERSONS IN ORDER TO AVOID A HAZARD.
12. To maximize the life of the cleaner, remove it from the pool when not in use and store in a shaded area.
13. Use the product at an altitude less than 2000 m.
14. Pollution of the liquid could occur due to leakage of lubricants.
While the cleaner has been made to operate as safely as possible, we suggest you exercise reasonable care in the handling
of the cleaner and inspect the electrical cord frequently for damage or wear, as with any other electrical appliance. After
use, remove the unit and rinse with fresh water and remove any twists that may be present in the cord. Store the cleaner
and power supply in a shaded area.
HAYWARD only warranties the quality, performance and safety of its products when assembled with genuine
Hayward manufactured parts. Use of non-genuine Hayward manufactured parts will void all warranty.
Page 5 of 20

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS
Rev. C

Publicidad

Tabla de contenido
loading

Tabla de contenido