Hayward RC34 Serie Manual Del Usuario página 27

STOP
Dear Hayward Robotic Cleaner Owner:
Thank you for choosing Hayward. In order to achieve optimal performance, please read and follow
these steps:
1. The power supply unit is suitable for outdoor use. It should always be kept out of direct sunlight, in a
shaded area. It should never be exposed to temperatures of above 40°C.
2. Cleaner filter cartridges should be thoroughly cleaned after each use or as often as needed to ensure
cleaner's optimal performance. (See the Maintenance section for filter cleaning instructions)
3. Before using your cleaner and especially when opening the pool for the first time remove larger items
such as toys, large leaves, or other debris from the pool that may diminish the cleaner's performance.
Clean filter frequently when pool is excessively dirty.
4. For the first use, run cleaner for the full cycle (3 hours) to ensure a clean pool and give you a full
understanding of the cleaner's capabilities. Subsequent cleaning may only require the Quick Clean
cycle - 90 minutes (if so equipped).
5. In the Quick Clean Cycle the cleaner may periodically go to the wall but not necessarily climb to the
vertical position. This is a normal part of the programmed cycle.
6. Cleaner may stop in the middle of the pool and reverse during cleaning cycle. This is a normal part
of the programmed cycle.
7. DO NOT start cleaner out of the water. The unit will automatically shut off,
but it is best to unplug the power cord when unit completes cleaning.
8. Plug in only to a protected 230 V
from short circuits (RCD). Fit a 30 mA differential protection device to protect
people from electric shock caused by a possible break in the electrical
insulation.
9. Place the cleaner power supply so that it is at a minimum distance of 3.5 meters from the pool edge.
The length of the standard cleaner cable is 18.3 meters (60 feet).
10. Depending on the size and shape of your pool the entire length of the floating cable may not be
necessary. The floating cable should reach from the cleaner power supply to the furthest point in the
pool, plus the depth at the deep end of the pool. To reduce cable tangling any excess cable should
be coiled and placed next to the power supply.
HAYWARD only warranties the quality, performance and safety of its products when assembled with genuine
Hayward manufactured parts. Use of non-genuine Hayward manufactured parts will void all warranty.
Page 6 of 20
⚠ WARNING - READ THESE IMPORTANT
OPERATING TIPS BEFORE USING YOUR UNIT!
(+/-6%) outlet that is close and protected

Rev. C