Playing using the Delete Bank
1
Press PLAY MODE repeatedly until "SHUFFLE",
"PROGRAM" and "CUSTOM INDEX" disappear
from the display.
When using the remote, press CONT INUE.
The Delete Bank is recalled and the selected track
numbers appear on the music calendar.
2
Press B to start playing.
To cancel playing using the Delete Bank
Press W.
To start playing using the Delete Bank again
While "PROGRAM" or "CUSTOM INDEX" appears in the
display, press PLAY MODE repeatedly until these indications
disappear from the display or until "SHUFFLE" appears in
the display. The Delete Bank is recalled and you can start
playing by pressing >.
`Ç You can play in a random order using the Delete Bank
In Step 1, press PLAY MODE repeatedly until
"SHUFFLE" appears in the display (or press SHUFFLE
on the remote).
Erasing the Delete Bank
1
Insert the disc.
2
Press PLAY MODE repeatedly until "PROGRAM"
and "CUSTOM INDEX" disappear from the
display.
When using the remote, press CONTINUE or
SHUFFLE.
The display shows the stored Delete Bank.
3
Press ERASE to erase the Delete Bank.
"DELETE" in the Custom File indication
disappears.
Additional Information
Precautions
On safety
+ As the laser beam used in this unit is harmful to the eyes,
do not attempt to disassemble the cabinet. Refer servicing
to qualified personnel only.
¢ Should any solid object or liquid fall into the cabinet,
unplug the player and have it checked by qualified
personnel before operating it any further.
On power sources
+ Before operating the player, check that the operating
voltage of the player is identical with your local power
supply. The operating voltage is indicated on the nameplate
at the rear of the player.
+ The player is not disconnected from the AC power source
(mains) as long as it is connected to the wall outlet, even if
the player itself has been turned off.
* If you are not going to use the player for a long time, be
sure to disconnect the player from the wall outlet. To
disconnect the AC power cord (mains lead), grasp the plug
itself; never pull the cord.
+ AC power cord must be changed only at the qualified
service shop.
On placement
e Place the player in a location with adequate ventilation to
prevent heat build-up in the player.
* Do not place the player on a soft surface such as a rug that
might block the ventilation holes on the bottom.
¢ Do not place the player in a location near heat sources, or in
a place subject to direct sunlight, excessive dust or
mechanical shock.
On avoiding deterioration of sound quality
(CDP-XA7ES/XA5ES only)
* Do not touch the lens inside.
On using the stabilizer (CDP-XA7ES/XA5ES only)
+ Be sure to use the supplied stabilizer. If you use any other
stabilizer, you may damage the player.
On operation
e If the player is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture may
condense on the lenses inside the player. Should this occur,
the player may not operate properly. In this case, remove
the disc and leave the player turned on for about an hour
until the moisture evaporates.
On adjusting volume
+ Do not turn up the volume while listening to a portion with
very low level inputs or no audio signals. If you do, the
speakers may be damaged when a peak level portion is
played.