Publicidad
Idiomas disponibles
Idiomas disponibles
Getting Started
e
+ If you have a digital component with a coaxial digital
input connector
Connect the component via the DIGITAL OUT (COAXIAL)
connector using the coaxial cable (not supplied).
CD player
Digital component
©
a
©)
After making connections, press DIGITAL OUTPUT
on the player to turn on the DIGITAL OUT indicator.
Note
When you connect via the DIGITAL OUT connector, noise
may occur when you play CD software other than music, such
as a CD-ROM.
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Removing the notice sheet
The notice sheet is put on the player. Remove the sheet
before you use your player.
Where do I go next?
Now you're ready to use your player.
If you aren't familiar with how to play CDs, go to the section
"Playing a CD" on page 4.
Then, go to the following sections for other operations.
'Hooking Up the System
(for CDP-XA5ES/XA3ES)
Overview
This section describes how to hook up the UD piayer to
an amplifier. Be sure to turn off the power of each
component before making the connections.
E For CDP-XA5ES
LINE OUT
DIGITAL OUT
DIGITAL OUT
VARIABLE
OPTICAL
COAXIAL
CDP-XA5ES
LINE OUT
FIXED
To an AC outlet
Amplifier
0000
To an AC outlet
E
: Signal flow
Mi For CDP-XA3ES
DIGITAL OUT OPTICAL
LINE OUT VARIABLE
CDP-XA3ES
To an AC outlet
Amplifier
To an AC outlet
y : Signal flow
Publicidad
