Descargar Imprimir esta página

Toro 51539 Manual Del Operador página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety and Instruction Decals
Safety decals and instructions
are easily visible to the operator and are located near
any area of potential
danger. Replace
any decal that is dmnaged or lost.
ON BLOWER HOUSING
ON REAR OF BLOWER HOUSING
(Part No. 95-5106)
Assembly
Note:
Always turn off unit and unplug
from electrical
outlet before adding or
switching
attachments.
Blower
Slide tube onto blower outlet until tabs on tube snap
into latch (Fig. 3).
Note:
Inlet cover must be securely
locked
into position,
activating
interlock
switch, before blower will operate.
Pointer
on cover will be aligned with
pointer on housing when cover is
correctly
locked in position
(Fig. 4 & 5).
Note:
Blower is shipped with inlet cover
installed.
Vacuum
(Vacuum
tubes optional
on some models. Model
51541 Vacuum
Bag Kit optional
for Model 51539.)
1.
Grasp inlet cover and rotate it counterclockwise
to remove (Fig. 6).
,
,
41
.
POTENTIAL
HAZARD
• Motor impeller
rotates for a few seconds
after blower is turned off.
WHAT CAN HAPPEN
• Rotating
impeller
can cut or injure fingers.
HOW TO AVOID THE HAZARD
• Never remove
inlet cover when motor is
operating
or when unit is plugged
in.
Assemble
vacuum tubes by pressing
tubes
together
(Fig. 7). Line up arrows on outside of
tubes to ensure correct assembly.
Hold vacuum tubes vertically and place blower
inlet over top of tube (Fig. 8), Tubes will only fit
one way in blower inlet.
Rotate unit clockwise
until pointer on vacuum
tube aligns with pointer on housing
(Fig. 9, 10& 11),
Note:
Vacuum tube and housing pointers
must be aligned at locked position
before blower will operate.
Slide bag collar onto blower outlet until tabs on
bag collar snap into latch (Fig. 12).
EN-4

Publicidad

loading

Este manual también es adecuado para:

5154951582