Kenmore 665.60612 Guía Para El Uso Y Cuidado página 7

Removing and Replacing
the Microwave uven
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or
other injury.
if you need to remove your Microwave Hood
Combination for any reason, follow these simple steps:
To remove:
Unplug microwave oven or disconnect power.
, _._ I I1_ _ Remove filters and
vent grille.
L J____j, | _1_ "'-. If filters Q are installed,
push in at the tab and
_-'-LJ__ slide filter to the outside
edge to remove.
Remove the two
screws Q from the
top of the microwave
oven cabinet (the
screws located closest
to the front corners). Do not remove the screws
located towards the center of the cabinet.
_ Remove the vent grille (_. Set the screws and grille
aside. (If grille cannot be removed, see Step 4.)
3. After removing all oven
contents, including the
turntable and support,
tape the door in the
closed position. Then
remove the two bolts
_) securing the
microwave oven to the
upper cabinet.
4 Hold microwave
hood combination in
place with one hand.
Pull hook @ to release
microwave hood from
mounting plate. If grille
cannot be removed
(see Step 2), insert a
thin looped wire or
similar tool through an
opening in grille to
pull hook.
5 Grasp the microwave
oven cabinet. Rotate
the microwave oven
downward. (Be careful
that door does not
swing open.)
G. Lift off the support
tabs _ at the bottom
of the mounting plate.
Set the microwave
oven aside on a
protected surface.
To replace:
Carefully lift microwave oven and hang it on the
support tabs at the bottom of the mounting plate.
;2. Rotate the front of the microwave oven cabinet
downward. Thread the power supply cord through
the power supply cord hole in the bottom of the
upper cabinet.
& Rotate the microwave oven towards the cabinet.
Push the microwave oven against the mounting
plate until locking latch snaps into the cabinet.
4 Replace the two bolts securing the microwave
oven to the upper cabinet.
5. Untape door and replace the turntable and support.
/_i.. Replace the vent grille.
7 Replace the two screws in the top of microwave oven
cabinet (the screws located closest to front corners).
8. Tighten the two bolts securing the microwave hood
to the upper cabinet until there is no gap between the
upper cabinet and microwave hood.
_i_. Reinstall filters (see "Installing and caring for the
filters" in the "Caring for Your Microwave Oven"
section, if needed).
4© Plug in microwave oven or reconnect power.