Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
TROUBLESHOOTING GUIDE
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
Problem
Possible cause
Tool will not start
Lock button not pressed.
Front hand guard in the brake position
Blown fuse
Tripped RCD (Residual Current Device)
Mains lead not connected
Saw chain does not stop within
2 seconds when the tool is
Saw chain tension is too slack
switched off
Oil tank empty
Oil hole blocked on saw chain bar
Bar/saw chain appear hot/
smoking
Saw chain tension is too tight
Guide bar sprocket nose needs greasing
Saw chain on backwards
Chainsaw does not cut well
Saw chain is blunt
Debris in tank
Oil hole in cap blocked
Chainsaw not using oil
Debris in saw chain bar
Debris in oil outlet
SERVICE INFORMATION
BLACK+DECKER offers a full network of company-owned and authorized service locations. All BLACK+DECKER Service Centers
are staffed with trained personnel to provide customers with efficient and reliable power tool service. For more information
about our authorized service centers and if you need technical advice, repair, or genuine factory replacement parts, contact
the BLACK+DECKER location nearest you, or visit us at www.blackanddecker-la.com
36
Possible solution
Press the lock button.
Reset Front hand guard
Replace fuse
Check RCD (Residual Current Device)
Check mains supply
Check saw chain tension
Check oil tank level
Clean oil holes and clear the groove around the edge of the saw chainbar.
Check saw chain tension
Oil the guide bar sprocket nose
Check/modify saw chain direction
Sharpen or replace saw chain
Empty oil from tank and replace
Remove debris from hole
Remove debris and clean the saw chain bar
Remove debris
Publicidad
