Konig & Meyer AC 6001 Flex Manual De Instrucciones página 6

Technical data
Material
Load capacity
Dimensions
Adjustment
Packaging
Weight
Mounting
1.) Unpack and check product for damage and completeness
2.) Assemble the stand with the corded speaker
so they are hand-tight. The tightening torque must not exceed 8 Nm maximum.
Base, connecting plate, base tube, extension tube:
steel, powder coated, black or white
Hexagon bolt, clamping bolt, clamping screw, washer:
steel, galvanized
Clamping nut: plastic, galvanized steel
Guide shells: plastic, black
Rubber pad: rubber
Teufel EFFEKT and CS 25 FCR Mk3, max. 1.2 kg
(W) 220 × (D) 240 × (H) 795 - 1,195 mm
Height from floor to top of stand 795 - 1,195 mm
in eight steps of 50 mm
(W) 850 × (D) 245 × (H) 80 mm
Piece 4.6 kg, pair 9.2 kg
1 Accessories bag:
2x clamping bolt
4x hexagon bolt M6 x 20 mm
2x clamping nut
2x connecting plate
1x washer ø 6.4/17.8 × 1.6 mm
1x wrench SW10/13
2 2x base
3 2x base and extension tube
1 Push the cord through the extension
tube, base tube and base from the top.
2 Push the connecting plate into the
opening. The plate must sit flush with
the base tube when in place.
NOTE: The connecting plate and the
base tube have different crosspiece
lengths to ensure that the parts are
assembled in the correct position. Pay
attention to the crosspiece lengths. The
components are easy to connect when
positioned correctly.
3 Insert the base tube into the base and
screw the two hexagon bolts into place