Konig & Meyer AC 6001 Flex Manual De Instrucciones página 7

3.) Attach the speaker to the stand
!Because of the adjustment possibility, there is a risk of crushing between the components!
4.) Adjustment of the height
Maintenance, cleaning and repair
u Maintenance: Regularly check if the screw connections are tight.
u Cleaning: Use a slightly damp cloth to clean the speaker stand. Do not use chlorinated or
u
abrasive cleaning agents. These will cause damage to the surface and varnish.
u Repair: Immediately repair any damage that occurs and stop using the speaker stand.
u
Maintenance work may only be carried out if you have the necessary knowledge. If any parts
u
are missing,contact the manufacturer at www.k-m.de.
Insert the clamping bolt from the front through the ope-
ning in the extension tube and loosely screw into place
with the clamping nut. Hang the speaker from the
clamping bolt using the key-hole opening on the spea-
ker. Make sure the bolt is fully inserted into the key-
hole opening. Tighten the clamping nut so that it is
hand-tight.
NOTE: EFFEKT speaker: opening 1
NOTE: in the extension tube.
CS 25 FCR Mk3 speaker: opening 2
NOTE:
NOTE: in the extension tube.
 The stand is properly set up.
 The stand and speaker are firmly screwed together.
 The stand is set up on a level and load-bearing surface.
NOTE: The extension tube must be held when opening the
clamping screw.
Open the clamping screw using the washer provided or a suit-
able tool 1, and set the desired height 2. Once again, tighten
the clamping screw until it is hand-tight 3. Make sure that the
clamping screw is inserted in the hole provided for this purpose
on the extension tube.