Konig & Meyer AC 6001 Flex Manual De Instrucciones página 8

Fault and troubleshooting
Fault/cause
Base cannot be connected to the
base tube
Connecting plate cannot be fully
inserted into base tube
The stand wobbles or is unstable
Speaker does not attach securely
or cannot be clamped
Set height is not maintained;
the extension tube retracts
auto-matically
Storage, disposal
Store the speaker stand in a dry place.
Recycle the components after they are disassembled:
u Scrape all components made of metal.
u Recycle or reuse all plastic, paper, and cardboard components.
u Sort all other components according to material composition and dispose of them
u
according to local regulations.
Contact information
KÖNIG & MEYER GmbH & Co. KG
Kiesweg 2
97877 Wertheim
Germany
Phone: +49 9342/8060
Fax: +49 9342/806-150
E-Mail: contact@k-m.de
Web: www.k-m.de
29620-000-55 / 29620-000-57 Rev.01 03-80-963-00 8/23
Check/Remedy
● Observe the installation lock or the length of the bar on
● the base tube.
● Observe the assembly lock or the length of the bar on
● the connecting plate.
● Check the surface and area where it is set up.
● Check the screw connection between the base and
● base tube and re-tighten if necessary.
● Be sure to use the right mounting hole for your speaker.
● The clamping bolt must be fully inserted into the keyhole
● opening.
● Re-tighten clamping nut.
● Check or ensure that the clamping screw is immersed
● in a hole in the extension tube